Silicon carbide powder Hapstone for leveling stones 100g
Silicon carbide powder Hapstone for leveling stones 100g
Silicon carbide powder Hapstone for leveling stones 100g
Silicon carbide powder Hapstone for leveling stones 100g
Silicon carbide powder Hapstone for leveling stones 100g
  • SKU: SICPOWDER-HAP100G-F80
  • Availability: in stock Many in stock Out of stock You can purchase this product but it's out of stock

Silicon carbide powder Hapstone for leveling stones 100g

$7.00

International Orders: Please note that orders made outside the US will be shipped from our warehouse in Ukraine.

 

Through use, your Sharpening Stones will show signs of wear. They may lose their flatness after a time. The Silicon carbide Hapstone leveling is used to restore your stones to their original flatness, keeping them in prime condition.

You can also choose a mirror for each fraction of Silicon Carbide. By selecting an additional option. 

(Size 200x200x4mm, the mirror is mounted on high quality rubber feet to avoid slipping during operation, the sides are ground)  

To use, sprinkle about a ½ teaspoon of the silicon carbide on the glass or a mirror, and add a little water.

By rubbing the stone against the abrasive grit, you will grind the high spots of the stone down until it is level again.

The SiC powder should always be coarser than a sharpening stone.

Take a slate pencil and put crosshatch pattern to the surface of the stone. Never skip this step. Your goal is to get rid of crosshatch completely. If you notice left-over of pattern somewhere, it means geometry is not flat yet.

Always add water to make a suspension, not dry SiC. Try to use glass area evenly. Your glass will wear over time because SiC affects glass too.

For hard stones, coarse SiC will be the major time consumer. When SiC disintegrates, put another pinch (refresh). If there is too much suspension, clean your glass. Use a straight edge or metal ruler to check flatness. If you are not sure, make crosshatch pattern again.


The abrasive hygiene should be a priority. Don't let single coarse particle to remain in fine lapping.


Silicon carbide 80 grit (200/160 mkm)

F 80
Flattening of very coarse stones (60 - 150 grit)

Silicon carbide 120 grit (125/100 mkm)

F 120
Flattening of any stones (180 grit and above)

Silicon carbide 280 grit  (60/40mkm)

F 280
Lapping of medium waterstones (400 - 1000 grit)

Silicon carbide 500 grit  (14/10mkm)

F 500
Lapping of fine waterstones (2000 grit and above), natural stones, alumina ceramic


Silicon carbide 1000 grit (5/3mkm)

F 1000
Lapping and honing of ultra-fine natural stones and sintered alumina ceramic

 

 

How to use

Warning! Respirator required to work with F1000 silicon carbide powder. Inhalation can cause illness.

The SiC powder should always be coarser than a sharpening stone.

Take a slate pencil and put crosshatch pattern to the surface of the stone. Never skip this step. Your goal is to get rid of crosshatch completely. If you notice left-over of pattern somewhere, it means geometry is not flat yet.

Always add water to make a suspension, not dry SiC. Try to use glass area evenly. Your glass will wear over time because SiC affects glass too.

For hard stones, coarse SiC will be the major time consumer. When SiC disintegrates, put another pinch (refresh). If there is too much suspension, clean your glass. Use a straight edge or metal ruler to check flatness. If you are not sure, make crosshatch pattern again.

The abrasive hygiene should be a priority. Don't let single coarse particle to remain in fine lapping.

RELATED PRODUCTS

BACK TO TOP