No Products in the Cart
You're $ away from free shipping!
You're eligible for Free Shipping
TOTAL:
$0.00
Hapstone was established in 2012, The Ukraine based company set out to develop a range of sharpening systems to be affordable and practical.
Hapstone developed a sharpening system with multiple modules that attach to a universal base unit.
The steel base is solid so it does not tip when sharpening, underneath are rubber feet to stabilize and protect most surfaces from scratching.
The upright shaft has two receiving bolts that accept all the Hapstone modules and get tightened down once the module is in place.
The down side to the M3 module is that it doesn't allow the knife to be rotated and held in the exact place accurately every time, it does use a guide to help you reposition the knife into the same position but can be inconsistent at times.
The Hapstone R2 is the most versatile of the modular systems as it offers a 360 degree rotating cross bar that allows the user to affix any clamp configuration they desire from the Hapstone line-up.
At the rear of the module is a large knurled knob that controls the spring pressure of the cross bar, tightening the spring will mean that more force is required to turn the blade over, and the looser the spring the easier it is to rotate.
The user has the freedom to adjust this to a tension that they are happy with.
Once the tension has been set, you can mount up your clamps in any configuration for large and small blades, the more clamps added means there will be less flex in the blade resulting in a more consistent sharpening angle across the entire bevel.
Below: 4 angled clamp setup
Below: angled clamps for small knife
Below: Angled clamps for medium knife
The Hapstone V8 module is a beefed up version of the M3 model, it uses the same strong magnets but also offers a wide cross bar with sliding magnet bases.
The wider platform allows longer knives to maintain their sharpening angle without deflection in the blade as pressure is added.
It maintains the same alignment guide as the M3 version.
Below: Hapstone V8 module
The Hapstone Scissor module will allow you to sharpen higher degree angles from 35° to 85° on most common scissor types.
The module uses clamps to hold the scissors in place while sharpening.
Below: Scissors mounted in the clamps
Check out the Hapstone range of sharpening systems an accessories HERE
